Technical data

15
2.3 STANDARD COMPONENTS
The CO-MR standard components are shown in Figure 2-3 and listed in Table 2-10.
The ITEM NO. column indicates the number used to identify items in Figure 2-3.
1
2
3
4
5
6
FIGURE 23. STANDARD COMPONENTS
8
9
10
11
12
7
13
14
TABLE 210. STANDARD COMPONENTS
ITEM NO. DESCRIPTION
QUANTITY
1
CO-MR Night Vision Clip-On System
A night vision device intended for use in conjunction with a day scope.
1
2
Single Lever-Lock Quick Release Picatinny Mount #27
A quick release mount used to install the CO-MR on a Picatinny/ Weaver rail.
1
3
М4×8 Flat Head Socket Cap Screw
Used for attaching the mount or the optional Weaver rail to the CO-MR.
2
4
Advanced Wireless Remote Control
Wireless control used to operate the CO-MR in short-time activation mode.
Ensures quick and silent CO-MR activation/deactivation. Delivered with two
CR2016 (3V) batteries installed.
1
5
Picatinny Adaptor for Advanced Wireless Remote Control
A adaptor mounted to the Picatinny rail of an weapon. Allows the Advanced Wire-
less Remote Control to be installed on the weapon.
1
6
Light Suppressor 1
A rubber cup mounted to the CO-MR output lens to reduce light scattering. Used
when installing the CO-MR in front of day scopes with lens housing outer diameter
overtherange25.4to42mm.
1
7
Light Suppressor 2
A rubber cup mounted to the CO-MR output lens to reduce light scattering. Used
wheninstallingtheCO-MRinfrontofACOG4×32scope.
1
8
Light Suppressor 3
A rubber cup mounted to the CO-MR output lens to reduce light scattering. Used
when installing the CO-MR in front of day scopes with lens housing outer diameter
overtherange47to50mm.
1
9
IR850 Detachable Long Range Infrared illuminator
Long-range infrared illuminator equipped with a Weaver mount. Should be used
when there is little to no ambient light.
1