Manual

31
8. Cleaning the locking lugs.
The hidden surfaces of the locking lugs of the barrel must be cleaned and protected.
Place a chamber cleaning brush on the chamber cleaning tool. Dampen the brush with
CLP and screw it into the chamber with a clockwise motion until the wide diameter steel
brushes enter the barrel extension. Rotate the brush three times and, while continuing to
rotate clockwise, pull it from the chamber.
If no brush is available, place two cleaning patches on a cleaning rod with one end of the
patches protruding only slightly, and the other end protruding approximately two inches.
Wet the patches well with CLP and wash the hidden areas of the barrel extension by
placing the patches in close contact and rotating the rod.