Datasheet

Creating an Application
ARM DUI 0064D Copyright © 1999-2001 ARM Limited. All rights reserved. 3-3
3.2 Creating and building a simple project
This section describes how to create and build a simple project. It uses source files from
the
dhryansi
example supplied with ADS 1.2 to give an introduction to configuring tool
options and using build targets in the CodeWarrior IDE.
Note
This example assumes that you have installed the example code supplied with ADS 1.2,
and that you have installed in the default installation directory. Example code is
installed by default unless you have chosen a minimal install or a custom install.
The section contains the following information:
Creating a new project from ARM project stationery
Adding source files to the project on page 3-5
Configuring the project build targets on page 3-7
Building the project on page 3-12
Debugging the project on page 3-13.
3.2.1 Creating a new project from ARM project stationery
To create a new project, and compile and link an application using the CodeWarrior
IDE:
1. Select Programs ARM Developer Suite v1.2 CodeWarrior for ARM
Developer Suite from the Windows Start menu to start the CodeWarrior IDE.
2. Select New… from the File menu. A New dialog is displayed (see Figure 3-1 on
page 3-4).