User Manual

7
Set Up Your System
3. Plug the AC adapter into an electrical outlet.
4. Press the On-O button on the back of the base station.
The Power LED and Internet LED light green in about two minutes.
Your base station is set up.
Arlo Base Station LEDs
See the following image for explanations for green, amber, and blinking LEDs:
Green
The base station
is powered on.
Blinking green
A firmware update
is in progress. DO
NOT TURN OFF THE
BASE STATION OR
CAMERAS.
O
The base station
is powered o.
Green
The base station
is connected to
the Internet.
Blinking green
The base station is
sending data over
the Internet.
Amber
The base station is
connected to the
router but did not
get an Internet
connection.
O
The base station is
not connected to
your router.
Green
Cameras are
connected to the
base station.
Blinking green
The base station
is attempting
to sync with a
camera.
Blinking amber
A camera is too
far from the base
station. Signal
strength is weak.
O
No cameras are
detected..
Amber
The base station
is booting.
Power Internet Camera