Brochure

Distributed by
Patented/Other patents pending. DVFR1W 0707REV 1008/30M
© 2007 Arlington Industries, Inc. REV 1008
Mount TVs flush against wall – Plugs stay in the box
Indoor IN BOX
™
Recessed Electrical Box
New Construction
Old Work
Thread (2) #8 x 3"
screws (supplied)
through the angled
holes in the outer
edge of the box.
Mount box to stud,
using positioning
tabs to allow for
finished wall
(drywall) thickness.
Install N
M cable
connector
(supplied).
Pull wires.
After wall
installation is
complete, wire
in receptacle.
Add trim plate.
(See steps 3 and
4 above.)
Angled
hole
Mount box to stud.
Use positioning tabs to
allow for wall thickness.
Cut hole next to stud.
W
i
re in receptacle.
Attach
paintable
trim
plate.
1 Cut hole next to stud
(3-3/8" x 6" for single-gang,
5
-1/4" x 6" for two-gang).
2 Install NM cable connector
(supplied). Pull wire.
Mount box to stud with (2)
#8 x 3" screws (supplied)
t
hrough the angled holes in the
outer edge of the box. Use posi-
tioning tabs
(see detail below)
to allow for drywall thickness.
3 Wire in receptacle.
(See below for
two-gang combo installation).
4 Attach paintable trim plate with
(2) #6 x 1/2" screws (supplied).
1
2
4
3
1 Stauf
fer Industrial Park
Scranton, PA 18517
800/233.4717
F
ax 570/562.0646
www.aifittings.com
Arlington
(single-gang shown)
Positioning
tabs
Two-gang installation
Use supplied separator...
...for combination power and
low voltage device installations.
Single-gang installation
Receptacle wired into
single-gang box.
CSA w/
grounding lug
only
R
R