Submittal

CATALOG UPC/DCI/NAED CABLE (OD) CABLE CABLE UNIT STD
NUMBER MFG. #01 8997 OUTSIDE TYPE SIZES PKG PKG
DIAMETER
3810AST 00385
.370 50 500
t
o
.510
383810AST 10937
Duplex 25 100
3/8" Flex*
.560 to .610
4010AST
40355 .405
t
o
50 500
.610
404010AST 40533
Duplex
25 100
3/8" Flex*
.560 to .610
5010AST 00517 .580
1/2" KO to 25 250
.780
10/3, 10/4, 8/2, 8/3
505010AST 50720 25 25
Duplex
3/4" 1/2" Flex*
KO .590 to .820
7510AST .895 25 25
3/4" KO 55090 to
1.035 8/4, 6/4, 6/3
SNAP
2
IT
®
Largest Line. Widest Cable Ranges. Fastest Installation.
MC Cable Connectors
Patented
4010AST
Exploded View/Components
Screw holds clip permanently in place
Loosen to remove cable
Angled, two-prong clip
locks down on cable,
holding it securely in place
Insulated
throat
7510AST
Back view
Angled,
heavy-duty
two-prong clip
holds large
cables securely
in place
14/2, 14/3, 14/4,
12/2, 12/3, 12/4,
10/2, 10/3
For steel and
aluminum:
MC/HCF/AC
NEW MC-PCS
MCI-A
AC90, ACG90
Flexible
metal
conduit
For steel and
aluminum:
MC/HCF/AC
NEW MC-PCS
MCI-A
AC90, ACG90
F
lexible
metal
conduit
For steel and
aluminum:
MC/HCF/AC
NEW MC-PCS
MCI-A
AC90, ACG90
Flexible
metal
conduit
For steel and
aluminum:
MC/HCF/AC
MCI-A
AC90
Flexible
metal
conduit
.405 to .580
.405 to .610
.610 to .780
.550 to .850
6/3, 4/4, 4/3, 3/3
Our 3810AST through 7510AST SNAP
2
IT
®
connectors install just as fast and cost the
same as our other Snap2It fittings, but
cable insertion is even easier!
• Easy installation snap cable into
fitting – assembly into box...No tools!
• Angled clip locks onto MC cable
No pullout
• Removal, reusable
From cable: Loosen screw on top of
connector. Pull cable out.
From box: Slip screwdriver under
Snap-Tite ring and twist (photo on back).
Snap2It Connectors with Insulated Throat
and
Angled Two-prong Clip
14/2 and 12/2
with and
w/o ground;
14/3 and 12/3
14/2, 14/3, 12/2, 12/3
3/4" Flex*
1.045 to 1.035
LARGER SIZES
Check that the cable’s outer diameter (OD) listed by the cable manufacturer is within the OD cable range listed for the fitting.
The cable jacket should never be able to go through the end stop (of fitting.)
*CSA Listed w/ anti-short bushing ONLY
10/3, 10/4,
8/2, 8/3, 8/4
6/2, 6/3
.900 to .970
.370 to .510