Safety Instructions

FUNCTIONS ON THE REMOTE CONTROL
(1) Function: To select between the different functions such as the FM tuner, CD player, USB input, SD
input ,Bluetooth and Phonograph.
(2) Power: the POWER button on the remote control diagram to exit standby mode and enter FM Radio
Mode.
(3) VOL - : reduce voice, press the button repeatedly or press once and hold down until you reach the
desired volume level.
(4) Stop : press to stop a track.
(5) PREV/F.B(fast back): press to go to the previous track or rewind back through a track. You can then
press the play button to start playback.
(6) Program: Allows you to program only particular songs of your choice to playback from your music source.
（The details are on page 11 of this book）.
(7) Folder-: press to skip to the first track in the previous folder. If the Jukebox is in random (“RAN”) mode
the folder skipping function will be disabled.
(8) Repeat: press to replay one particular song. press the button once repeating ONE song only, press
the button twice repeating ALL the songs, press the button three times repeated RANDOM play.
(9) Auto: press to Radio Auto-search and save stations.
(10) ST/MONO: Stereo/Mono Selection in FM Radio.
(11) PRE-: To playback previous stored radio station.
(12) MEM: tune the radio to the desired station The Jukebox has a 20 station memory to store the user’s
favourite radio stations In the condition of CD, CD door opening and closing.
(13) PRE+: To playback a next stored radio station
(14) EQ: To change the Equalizer setting equalizer settings preloaded on to the Jukebox are Pop (POP)，
Rock (ROC), Classical (CLA).and Flat (FLA),（To start the use of "POP" model for default）.
(15) Folder+: press to skip to the first track in the next folder. If the Jukebox is in random “RAN” mode the
folder skipping function will be disabled.
(16) NEXT/F.F: fast forward, press to go to the next track or fast forward through a track. You can then press
the playback button to start playback.
(17) VOL + : increase the voice, press the button repeatedly or press once and hold down until you reach the
desired volume level.
(18) Play/pause button: press to play or pause a track.
TURNING ON THE LIGHTING EFFECTS
The Jukebox The features 2 see see colour changing LED light tubes that are using The LED
CONTROLLER. There are also several other multicoloured LED lighting effects that are
featured in The CD player and USB/SD compartment and The at The bottom of The speaker
panel.
To turn on the LED lighting effects simple press the LIGHT button on the control panel
(number 24) from the graph on page 4. All the LED lighting effects will illuminate.
Operation Instructions of magic Controller Function of remote panels
This controller is controlled by 24 key infrared remote control,the key functions
are as below:
14
Note: If you need to clear the last saved radio program, press "AUTO" to
search again and save the radio.
Play mode selection
Press "MODE" button until led display indicate "...",As shown in the figure below
CD operation (CD should be placed on the tray with the label side
up)
a. Press "MODE" button until led display indicate "- - - -", then display will show number of songs and then
begin to start playback.
b. Press the (Open/Close) button on the control panel, or the EJECT button on the remote control to open the
CD tray.
c. Load the CD on the CD tray, with the label facing up and the shiny side facing down.
- This unit has been designed specifically for sound reproduction from compact discs bearing the mark.
No other discs can be used.
- To remove a disc from its storage case, press down on the center of the case and lift the disc out,
holding it carefully by the edge.
-Fingerprints and dust should be carefully wiped off the disc recorded surface with a clean cloth
(not included)
-Never use chemicals such as – record sprays, anti-static sprays or fluid, benzene or thinner
to clean compact discs. Such chemicals will do irreparable damage to the discs plastic surface.
-Discs should be returned to their cases after use to avoid serious scratches that could cause
the laser pick up to skip.
-Do not expose discs to direct sunlight or high humidity and temperature for extended periods.
Log exposure to high temperature can warp the disc.
-Do not stick paper or write anything with a ballpoint pen on the surface of the label side.
-Do not use irregular shaped CD’s (Octagonal, heart-shape, etc) all of which can damage the unit.
7