Troubleshooting Guide

TURNING ON THE LIGHTING EFFECTS
The Jukebox features 2 colour changing LED light tubes that are displayed on the
Jukebox parts ,There are also several other multicoloured LED lighting effects
that are featured in the CD player and USB/SD compartment and at the bottom of
the speaker panel.
To turn on the LED lighting effects simply press the LIGHT button (USB control
panel on page 7 - serial no. 25). All the LED lighting effects will illuminate.
NOTE: The lighting effects operate independently of the POWER button (USB
control panel on page 7 - serial no. 24). The LIGHT button controls The power to
The lighting effects and The on The back of The machine.
On the rear of the Jukebox, there is an LED Light Mode Switch (Number 4 On the
Jukebox with parts diagram item 4）， the Colour Changing LED Light Tubes will
fade in and out of several different colours continuously. When set to HOLD mode
the LED Light Tubes will be illuminated in only one colour. By switching to PLAY
mode, the
LED Light Tube will begin to cycle through the colours. By switching back to
HOLD, different colours can be selected to display and hold (please note that
these colours have been predetermined and may not be the exact same colour as
the light tube was illuminated when switched to “HOLD” mode).
To turn OFF the lighting effects all together simply press the “LIGHT” button once
again, and all lighting effects will no longer be illuminated.
Note: in the "hold" mode, there may be no visible light, is normal (need to adjust
the switch).
14
6. The appliance should always be used or stored on a flat stable surface indoors.
7. Ventilation - The appliance should be situated so that its location or position does
not interfere with its proper ventilation. For example, the appliance should not be
situated on a bed, sofa, rug, or similar surface that may block the ventilation
openings; or placed in a built-in installation, such as a bookcase or cabinet that
may impede the flow of air through the ventilation openings.
8. Heat - The appliance should be situated away from heat sources such as
radiators, heat registers, stoves or other appliances (including amplifiers) that
produce heat.
9. Power Sources - The United States is 120 vac-60Hz; Japan is 100
vac-60Hz.Power-Cord Protection - Power supply cords should be routed so that
they are not likely to be walked on or pinched by items placed upon or against
them.
10. Power cords should be regularly inspected and if any damage is discernible
then stop using and consult a qualified electrical technician.
11. This item is fitted with a 3amp fuse only.
12. Cleaning - The appliance should be cleaned only as recommended by the
Manufacturer.
13. Non use Periods - The power cord of the appliance should be unplugged from
the outlet when left unused for a long period of time.
14. Object and Liquid Entry - Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings. Switch off immediately
at power source if the item comes into contact with liquids and refer to a qualified
electrical technician.
15. Refer to s suitable qualified technician if the appliance is damaged, needs
servicing or has been dropped.
16. Servicing - The user should not attempt to service the appliance beyond
general cleaning and changing of stylus.
17. This appliance / product is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning the
use of the appliance by a person responsible for their safety. Children should be
supervised so that they do not play with the appliance.
3