How to Guide

SM678 | Slim-Grip
®
Ultra
™
Multi-Surface Sticky Suction Mount
!
Consumer Hotline:
USA [phone]
INT’L [phone]
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan & China
© Copyright 2014 Arkon Resources, Inc.
The Mobile Mounting Specialists™
Safety Precautions
Arkon is not responsible for any damages caused to your vehicle, your device, or yourself due to the
installation or use of this mount.
Do not install Arkon products over an air bag cover or within the air bag deployment zone. Arkon
Resources, Inc. assumes no responsibility of liability for injury or death as a result of car crashes and /
or air bag deployment.
rev.042514
SM678
Slim-Grip
®
Ultra
™
Multi-Surface Sticky
Suction Mount
Insert device, adjust mount as needed.
Adjust support legs as needed.
3
2
Do not place mount in or near an air bag deployment zone or where it will obstruct view of
the road.
!
*If the sticky suction base becomes dirty or loses stickiness, rinse under warm water and let air dry.
IMPORTANT: Some dashboards with heavily textured or porous surfaces may require you to push
down on the suction base while engaging the suction lock lever to achieve the suction required to
hold the mount in place.
Package Contents:
IMPORTANT: Select the appropriate size support legs and install to holder. For large smartphones,
midsize tablets, and large cases, use included long support legs.
SM060-2 - Slim-Grip
®
Ultra
™
Holder
CM078-SBH - Multi-Surface Sticky Suction Mount
AP020 - Adhesive Mounting Disk
*If necessary, use included long legs for large devices or cases.
Push down on
lower legs to
mount device
Slide legs to adjust
Adjustment
Ring
Adjustment
Knob
DASHBOARD MOUNTING WARNING: The sticky suction pedestal SHOULD NOT be used on some
types of dashboards. It may leave a PERMANENT indentation on dashboard surfaces made of soft
vinyl, leather, or similar materials. To prevent permanent indentation marks, use the included adhesive
mounting disk when mounting on soft dashboard surfaces.
Attach mount to dash or windshield, engage suction lock.
Connect holder to the mount.
1
Suction Lock
Lever
IMPORTANT: With certain dashboard surfaces you
may need to push down firmly on the suction base
while engaging the suction lock lever to create enough
suction to hold the mount.
Push down on
suction base
Attach holder to
mount
P
s
OPTIONAL: Use included adhesive disk* for dashboard mounting.
*Let mounting disk adhesive cure for 24 hours before use.
Adhesive Mounting
Disk*