Installation and Wiring The Acumen SCOOTER consists of the following main components; • SCOOTER main unit ECU (Electronic Control Unit) • SCOOTER wiring harness • 1 x Remote Fob • Fitting kit including System fuse, spare fuse & Red LED system indicator Tool Required: • • • • • • • • • Pliers/Cable strippers/Cable cutters Drill with 5.
Installation and Wiring To make the alarm active, you only need to connect the Red, Black and Brown wires Connect the system wires as follows: A larger version of the wiring diagram can be found on the back page. The RED wire is the alarm positive feed. DO NOT connect this directly to the scooter battery, but connect to the positive terminal of the starter solenoid. Use the Red-tagged ring terminal from the fit kit. The BLACK wire is the alarm negative connection.
Optional Wiring Acumen recommends that the following wires are connected to get full basic operation of the SCOOTER System, however, they are not critical to the operation of the system. Flashing Indicators The two PINK wires are for the indicators. Connect one Pink wire to the LH indicator, and the other Pink wire to the RH indicators. Ensure you connect these wires to the positive side of the indicators - if you connect to the negative side of the indicators the alarm fuse will fail.
Operation The visual indications are based on the assumption that the Pink wire (Indicators) and the Black/Red wires (LED) have been connected (See page 3). The standard key fob has three buttons; Lock, Unlock and Silent. To Arm the system. Convenience (Ferry) Mode In Convenience mode the movement/nudge sensor will cease to function. With the alarm active, press the Silent button. You will get one long tone and one flash of the indicators.
New Key Fob/Lost Key Fobs If you can disarm the system - ie; you have a working fob and need to add another; If the system is dis-armed but you don’t have a working fob (you have lost all working fobs); If the system is armed and you don’t have a working fob (you have lost all working fobs); 1. Switch ignition off 1. Switch off the scooter ignition 1. Ensure the scooter ignition is switched off. 2. Disarm the system from the fob 2. Remove alarm fuse 2. Remove the alarm fuse 3.
Troubleshooting Spares and Accessories 1. The alarm will not react to the fob a. Check the fob batteries (type CR2016). b. Place the fob as near as possible to the alarm system main unit. If it will now disarm there are probably spurious radio signals in the vicinity. Move the scooter to another area. Acumen can supply a range of spares & accessories to enhance the features of the SCOOTER system: c. 2. 1. Spare and replacement remote fobs and batteries. 2.
Wiring Diagram
