User Manual

Arkbird FPV
-5-
Note: Check CH5 and CH6 reverse through radio monitor：
push throttle, CH5 and CH6 to 0%, the CH3, CH5, and CH6 status shown on radio shall be
like picture below (Or check through servo).
3. Neutral Check
Neutral point alignment needed under first installation, changing of Vertical/Level
installation, not using for weeks, or temperature variation is more than 10 degrees.
Pushing CH5 and CH6 to minus (0%) and moving CH1 stick to left or right side within 3
seconds after power on can enable neutral point check.
Aileron all the way to the right means it is waiting autopilot be put down,
Put the autopilot paralleled to the ground (Please prop up if there is a landing gear), and move
CH1 left and right to do 3-seconds neutral point check.
Aileron will be back to center once finished.
4. Manual Mode
Radio Stick and SUB-TRIM back to center, set radio travel range as 100%.
Switching to Manual Mode, Arkbird will not participate control, set manual control’s reverse
through radio, adjust plane’s CG and travel angle.
5. Reverse Balance Mode assistant Control
Switching to Balance Mode, by pushing CH5 to 100% and CH6 to 0%, if the neutral point is
correct, rudder, aileron and elevator shall be at the neutral position, otherwise please check the
neutral point again.