User Manual

Arkbird FPV
-3-
1. Wiring
（Check carefully before power on, incorrect wiring will damage the autopilot permanently!）
1. The pins of RX in & Servo out shall stay forward (toward flying direction), the side with 4P
dip switch shall be upward or vertical installed toward right wing.（Default is level installation）
2. Put on heat-shrink tubing, fix by sponge and cable tie. Please keep away from motor to avoid
vibration and reducing the accuracy of sensor.
3. While using on flying wing, connect channel 1 output to right servo and connect channel 2
output to left servo. DISABLE the mix function from transmitter, switch Dip switch 4 to “0” to
enable flying wing mix.
4. While using on 3-channel plane, connect channel 1 output to rudder to steering.