User Manual

Arkbird FPV
-7-
3 5V Dual Power Supply
On broad OSD 12V to 5V regulator , with 5V BEC(form ESC) supplies power to the CPU module at the same time.
If OSD function is not used, please plug in OSD 12V power as well to prevent a lack of power supply for 5V
electronic speed controller.
4 Installation:
1. The pins of Servo & Radio RX shall stay forward (toward flying direction), the side with soldering dot shall
be upward or Vertical toward right wing. （Default is level installation）
2. Keep GPS antenna upward placed and away from interference sources such as image transmission and
camera.
3. Put on heat-shrink tubing, fix by sponge and cable tie. Please keep away from motor to avoid vibration
which will reduce the accuracy of sensor.
4. While using on flying wing, connect channel 1 output to right servo and connect channel 2 output to left
servo. DISABLE the mix function from transmitter, switch Dip switch 4 to “0” to enable flying wing mix.
5. When using on V-wing, connect Channel 2 output to the right V-wing; attach Channel 4 to the left V-wing.
DISABLE the mix function from transmitter, enable V-wing mix in the OSD menu(Flight Parameters).
6. While using on 3-channel plane, connect Channel 1 output to rudder to steering.
7. When setting return-to-home, please take off propellers for safety concern.