User Manual
Arkbird FPV
-10-
6 GPS & Save Home Position
After power on, Arkbird will start to search GPS satellite and save the first valid position as Home.
During searching, the elevator will be up and any manipulation of radio stick is invalid. If need to skip the
searching, please push CH6 more than 75% and push CH1 to left or right side for 1 second.
Once skipped the searching, it CANNOT switch to RTH mode, RTH logo will flash but it is balance mode.
Flight OSD Interface
1. When Arkbird is auto piloting the plane(RTH mode、Cruise flight), the lower right will display Roll, Pitch
control Angle Value and Throttle Value, Adjust Autopilot if these angles not appropriate.
2. The idle current is 0.8A while turning off the throttle, if the readout is wrong, please enter the OSD menu
and exit to reset the current value.
3. Please reduce the motor vibration to keep the “vibration value” more than 65 (99 is the most ideal
situation).
4. Pay attention to GPS satellite quantity, less than 7 will result mistake positioning.