User Manual

-6-
3. Installation:
1. The pins of Servo & Radio RX shall stay forward (toward flying direction), the side with
soldering dot shall be upward or Vertical toward right wing. Default is level installation
2. Put on heat-shrink tubing, fix by sponge and cable tie. Please keep away from motor to avoid
vibration which will reduce the accuracy of sensor.
3. While using on flying wing, connect channel 1 output to right servo and connect channel 2
output to left servo. DISABLE the mix function from transmitter, switch Dip switch 4 to “0” to
enable flying wing mix.
4. While using on 3-channel plane, connect channel 1 output to rudder to steering.
5. When setting return-to-home, please take off propellers for safety concern.