User Manual

Arkbird
8
Main Menu
"Set HOME" --------- Save home position
"Set PID Parameters" --------- Set PID Parameters
"Set RTH Parameters" --------- Set RTH (Return to Home) Parameters
"Set OSD Parameters" --------- Set OSD Interface
"------------------"
"Flight Parameters" --------- Reverse and delta-wing mixing
"Fence Area Set" --------- Set Fence Mode Area
"Way Point Set1" --------- Set Way Point Mode1
"Way Point Set2" --------- Set Way Point Mode2
"Reset All to Default" --------- Moving stick to right side for 2 seconds to reset to default
Set PID Parameters
Please adjust the travel range and neutral point mechanically, do not adjust through radio.
"Roll Ctl " ---------Roll Control % equivalent to travel range
"Pitch Ctl " ---------Pitch Control %
"Yaw Ctl " ---------Yaw Control %
"------------------"
"Neutral Check" ---------Neutral Check
Neutral point alignment needed under first installation, not using for a
while, or temperature variation is more than 10 degrees.
Aileron all the way to the right means it is waiting stabilizer be put down,
OSD shows “Waiting Neutral Point Check.”
Put the stabilizer paralleled to the ground (Please prop up if there is a
landing gear), and move CH1 left and right to do 3-seconds neutral point check.
Aileron will be back to center once finished.
Note: Pushing CH5 and CH6 to minus (0%) and moving CH1 stick to left
or right side within 3 seconds after power on can also enter neutral point check.
"------------------"
" Custom Mode" ---------Custom Mode CH5 more than 50% and CH6 30% between 70%
"RTH" Return to Home Default
"Way Point" Way Point Mode, it is able to trace the waypoints of another
plane with Way Point Mode.
"HOVER" Cruise Mode
"Gyro" Gyro Mode, it will do compensation for unintentional attitude
changes.
"Attitude Source" ---------Attitude Source
"GPS" Attitude acquisition through GPS
"AR PRESS" Attitude acquisition through barometer
"Lock Dir/Heig" ---------Lock direction and height
"ON" Under balance mode, height and direction will be locked and then
flying straight when CH1 and CH2 stick back to center.