User Manual
Arkbird
7
OSD Setting:
Once turning on all system, Arkbird will start to search GPS satellite and set the current position as Home.
During searching, the elevator will be all the way up and any manipulation of radio stick is invalid. If need to skip
the searching, please push CH6 more than 75% and push CH1 to left or right side. Once skipping the searching, it
will use the last position as Home.
Flight Interface:
Please note that the vibration value 100 is the most ideal situation. Please reduce the vibration to keep the
value more than 65.
Sensor’s voltage means the output voltage from current and voltage sensor, it shall be about 2.4.
OSD and Menu
When it turns to flight interface, CH5 switches to Manual Mode, throttle to 0, and push CH1 to left or
right side for 6 seconds, it will enter into main menu. Exit the main menu while CH5 switches to auto mode.
Moving stick back and forth to change the value, pushing to right side to select, and pushing to left side
to exit and save parameters.
Main Menu