User Manual
Arkbird
6
2 ways of installation
Switching Mode through CH5 and CH6:
1. After installation, test OSD and the setting of radio are correct. Using CH5 and CH6 to switch flight mode.
2. While CH5 is less than 50%, it switches to Manual Mode
OSD shows
3. While CH5 is more than 50% and CH6 is less than 30%, it switches to Balance Mode shows ; While
CH5 is more than 50% and CH6 is between 30% and 70%, it switches to Custom Mode Way point Mode
and Cruise Mode , and while CH5 keeps more than 50% and CH6 is more than 70%, it switches to
Return-to-home Mode. shows .
Plus and minus
Setting Fail-Safe to Return to Home While Out of Signal
Fail-Safe is a preset position which will transmit while receiver is out of signal. Some receivers can set in the
radio menu, and some save the current position through receiver (probably through a button).
Please set according to the manual of receiver. Setting the fail-safe position the same as Return-to-Home
Mode through CH5 and CH6 (CH6 is 100%). And then turn off the radio to check if it switches to Return-to-Home
Mode .
Note: No need to set fail-safe from channel 1 to channel 4 as these four channels are controlled by stabilizer
under Return-to-Home Mode, which is not relevant to receiver.
The plane will enter into Return-to-Home Mode even not setting fail-safe of channel 1 to channel 4, also, it
can return to home while out of signal if setting CH5 and CH6 fail-safe position as Return-to-Home Mode.
Please find the appendix