User Manual
Arkbird
5
OSD menu again and exit to reset the current value.
Dual Power Supply:
On-board 12V to 5V regulation module provides power to OSD module and flight controller module. ESC 5V
only provides power to flight controller module.
While normal flight, it is ok to plug in ESC 5V only, OSD module has no power consumption.
However, we strongly suggest plug in OSD 12V to provide dual power for flight controller to prevent any
issue caused by ESC 5V power insufficiency.
While FPV flight, OSD 12V shall be power on before ESC 5V or simultaneously to avoid failed OSD
initialization.
Installation
1. The pins of receiver on OSD shall stay forward (toward flying direction), the side with soldering dots
shall be upward or on the right side toward right wing. Default is level installation
2. Put on heat-shrink tubing, fix by sponge and cable tie. Please keep away from motor to avoid
vibration and reducing the accuracy of sensor. It is recommended to fix 3P connector by Hot Melt Adhesive.
3. While using on flying wing, connect channel 1 output to right servo and connect channel 2 output to
left servo. Do not enable the mix function from transmitter, but through dip switch 4.
4. During setting return-to-home, please take off propellers for safety concern.
Vertical installation
Level installation