User Manual

Arkbird
15
3. Adjust Max Up and Max Down to make plane pitch up and down smoothly. (too prompt or slow are
improper)
4. Based on the height and distance expect to fly to adjust safe height as high as possible (If the flying
height is higher, please adjust this value more than 120m). Please set usual speed as minimum speed of
return to home.
Frequently Asked Questions
1. Incorrect PAL/NTSC selection Take off camera, and select PAL/NTSC in “Set OSD Parameters” again.
2. If not be able to enter Menu, please check if the end point setting on radio is too small.
3. For 3-channel plane, please connect Airbird output 1 channel to rudder to steering. Please also note Dutch roll
and swings produced. The solution is to reduce “Yaw ctl.”
4. For plane with wider travel range of aileron, elevator, and rudder, the compensation will be more sensitive.
Please adjust the position of servo link to reduce the travel range. And set travel range as 100% on radio.
Keep the travel range and set travel range as 100% on radio
Attention
Please read through carefully:
1. The design purpose of stabilizer is to keep balance of flight, it is not able to manipulate plane or prevent stall.
You must have sufficient experiences of fixed wing to control the flight.
2. The stabilizer is only for small-scale RC model. For safety concern, please do not install in plane for aerial
photography which might fly over crowd.
3. Please install the stabilizer depends on your demands and check the condition before flying every time.
4. Any equipments and electric products on the plane couldn’t be completely reliable, please using this system
following the instruction. The system provider is not responsible for any direct or indirect loss and consequence