User Manual
Arkbird
13
If the compensation direction is not correct, please move the dip switch 3 to the other side.
While First Flight, Please Check
1. If travel range is proper under Manual Mode
2. If compensation is correct under Balance Mode.
If OSD horizon display is correct. Compensation shall be precise and fast, if not, please do neutral point
alignment again.
Please fly under Manual Mode while the first flight, switching to Balance Mode at safe height, turning back
to Manual Mode and landing on any unexpected situation.
GPS and Return to Home Instruction
While switching to Return to Home Mode , no matter the plane is flying lower or higher than safe height,
it will adjust the flying height to safe height to go home.
Please check if the plane will return to home while switching to Return to Home Mode and turning off the
radio in visual range, and linger in about 30m (the way and direction of linger will be decided by the system).
Switch to Manual Mode on any unexpected situation.
Once lost GPS satellite, switching to Return to Home, the plane will go home automatically based on the
home angle of last position before out of signal. Switch to Balance Mode to landing.
Please keep an eye on the quantity of GPS signal and voltage value, fly carefully. Please note if the quantity of
satellite is less than 7, the positioning might not be correct.
Way Point Mode , using wireless data link, transmit the position to each one, and the positions will be
shown on OSD. Formation flying while switch to Way Point Mode .
Different from Return to Home Mode, the throttle of Way Point Mode should be adjusted manually; roll and
pitch can be balanced automatically but still need manual manipulation.
If no position transmitted, set Home as way point.