User Manual

Arkbird

Reverse under Balance Mode

Switching to Manual Mode by pushing CH5 to 0%, and then setting reverse function through radio.

Switching to Balance Mode by pushing CH5 to 100% and CH6 to 0%, basically, if the neutral point is

correct, rudder, aileron and elevator shall be at the neutral position, otherwise, please check the neutral point again.

1. Aileron: When rolling the plane to right, aileron shall produce a left compensation automatically. On the

contrary, when rolling to left, aileron will produce a right compensation. Please see as below:

If the compensation direction is not correct, please move the dip switch 1 to the other side.

2. Elevator When pitching up the plane, elevator shall produce a down compensation automatically. On the

contrary, when pitching down, elevator will produce an up compensation. Please see as below:

If the compensation direction is not correct, please move the dip switch 2 to the other side.

3. Rudder When yawing the plane to right, rudder shall produce a left compensation automatically. On the

contrary, when yawing to left, rudder will produce a right compensation.