User Manual

-4-
1Wirings
Attention:
Make sure connect according to the marked order of - + S. The black wire is the ground wire. It is close to the
upper side. The signal wire below is for the yellow socket. Check all the wiring before power on. Don't mistaken
12v and 5v so as not to cause damage to the equipment.
If your need to use RSSI function, please connect AIRSPEED METER on RX port, RSSI connect AR
port.
Mixed control output
Arkbird 2.0 provides various intelligent mixed control
Ordinary
Fly-Wing
V-Tail
Bi-motor
Bi-motor
Fly-Wing
Butterfly
Brake
CH 1
Aileron Y
Right surface
Aileron Y
Aileron Y
Right surface
Left-Outer
surface
CH 2
Elevator
Left surface
Right V-Tail
Elevator
Left surface
Right-Inner
surface
CH 3
ESC
ESC
ESC
Left ESC
Left ESC
ESC
CH 4
Rudder
Rudder
Left V-Tail
Right ESC
Right ESC
Left-Inner
surface
CH 5
Gimbal Roll
Gimbal Roll
Gimbal Roll
Gimbal Roll
Gimbal Roll
Gimbal Roll
CH 6
Gimbal Pitch
Gimbal Pitch
Gimbal Pitch
Gimbal Pitch
Gimbal Pitch
Gimbal Pitch
CH 7
Flap Y*
Flap Y*
Flap Y*
Flap Y*
Flap Y*
Right-Outer
surface *
1) When connecting CH7 to two Flap servos with a Y shape wire, you need a inversed servo, but when
connecting Butterfly Brake, there is no need using a inversed servo.
2) You can use CH1/7 mixed control, using two surfaces to achieve aileron & flap functions.