User Manual

-2-
10 Extended functions Meets all you need
Launch Assist Run up with aircraft in hands, when the speed is higher than 5kmph, the throttle will start
output and automatically control the take-off.
Fence mode Out of rectangle area or safe height, it returns automatically, best helper for beginner
Waypoint Mode It is able to trace the Way Point Set by menu.
Hover mode Regard the hover position as balance position, nose up and keep steady
Cruise flight Keep a straight & constant-height flight.
Flap control Lower the flap surface automatically when speed is insufficient.
Butterfly brake Mixed control Make the fly wing change its direction smoothly without aileron inclining
Flight Record Records the time, voyage, data of power consumption and various maximum records of the
flights.
Gyro Mode It will do compensation for unintentional attitude changes to keep 3D angle status.
PTZ output When the flight is tilting, channel 5&6 will give an opposite compensation, so as to level the
camera.
(Note ： Press Ctrl+ F to search the document for a specified function)
Attention
All the details can be found in our instruction. Please read carefully before operating and pay close attention
to the details and important parameters, in case you miss any important information which may leave hazards or
cause damage.
Reminding：
For the first installation, please power up after a wire check. Forcible satellite search interface will be
entered (incontrollable) every time you power up. You can pop-up manually and adjust rudder angle directions in
Manual Mode and auxiliary control in Balance Mode. A Neutral Point Check for the sensor is necessary. Also, you
need a fail-safe protection for the receiver in case your autopilot loses control when returning home. Adjust the
OSD voltage value before takeoff.
For the first flight, we suggest taking off with "Manual Mode". Check if the aircraft flies normally after
switching to “Balance Mode” in a level flight. Then switch to "RTH Mode" and check the autopilot by using OSD
parameter (see the last chapter in the instructions: Notes for Balance and RTH). Please keep an eye on the
important parameters during the flight (Vibration value, Satellite number, Speed and Altitude).
When the maiden flight test is done, Balance Mode can be used freely for taking off the autopilot, or you can
use extended functions such as waypoints, cruise flight or fence mode.