User Manual

-18-
Yaw Yaw Reverse
MIX More ways of mixed control include delta wing and V-tail wing, and Bi-motor plane,
Bi-motor flying wing and butterfly brake (mixed control of 1247channel).
Gimbal roll Norm/Inverse：Gimbal output of channel 5 left and right positive/negative
compensation;
CH8 : port CH5 is directly output of CH8 in
Gimbal Pitch Norm/Inverse：Gimbal output of channel 6 up and down positive/negative
compensation;
CH7 Norm/ CH7 Inverse：On the basis of Gimbal output of channel 6
positive/negative compensation, add stick's value of CH7.
CH7 : port CH6 is directly output of CH7 in
CH9 : port CH6 is directly output of CH9 in
Gimbal roll value Gimbal output value of channel 5 left and right compensation
Gimbal pitch value Gimbal output value of channel 6 up and down compensation
Please connect the output of channel 5 & 6 to the camera PTZ of servos. When the flight is tilting, channel 5&6
will give an opposite compensation, so as to level the camera.
Flap mode
CH7 (Default) CH7 output is directly the CH7 input
CH7/Speed CH7 output is control by the CH7 input and Speed. When the CH7 is at the two edges,
CH7 has the priority to control the flap surface. When the CH7 is in the middle, the speed will participate in
controlling the flap wing: Either airspeed or ground speed, when the lower speed is lower than “SafeSpeed”,
the flap wing will be lowered proportionally. When the speed is 0, FlapMax occurs. When the speed is over
SafeSpeed, Flapzero occurs.
OFF turn off the control and OSD Flap value display
Flap Max FlapMax (OSD displays F, 100% output flap quantity). When doing the commissioning,
the rudder will output FlapMax value. Correct FlapMax value can be set according to the rudder position; If
the flap wings move in the opposite direction, adjust the value across 50%;
Flap zero Flapzero (OSD shows F, 0% output flap quantity). When doing the commissioning,
the rudder will output Flapzero value. Correct Flapzero value can be set according to the rudder position; If
the flap wings move in the opposite direction, adjust the value across 50%;
If the flap servo moves different from the OSD "Flap value"(0-100%), there is no inverse option, you can
adjust Flapzero & Flapmax one over 50% and one lower than 50% ,for example setting (25%、57%) to (75%、
25%) will make the servo moves a different direction. Firstly adjust the parameters by OSD , then check CH7
of radio TX, set CH7 's manual control’s reverse through radio
Attention: The flap is an aerofoil movable device on the edge of the flight. It can deflect or slide downward, which
increases the lift force when flying. Flap wing output can release and retract slowly automatically (1.5s).It is