User Manual

-3-
Ⅰ. Software Installation
1.Requirement for installation environment
This software is applicable to PC, which supports Windows XP, Windows 7, Windows8, Windows 10, but does
not support Mac and Linux.
2.Use the program
3.Install NET Framework 3.5
Because this software is developed on NET Framework 3.5, “NET Framework 3.5 seems to be missing” may be
prompted when you open it, the cause to this case is that Windows XP does not contain this framework, but the
original Windows 7 is default with this framework that you may directly use it.
While Windows 8, Windows10 contains the framework of a higher version, you may download and install it
by following the prompt, or download it by searching “.NET3.5” in Google.
When you double-click to open it, “this software is risky” may be prompted by some anti-virus software or
security guards, and select “Trust” and continue the operation, please use it at ease because the official software
has no malicious program.
4.Install the serial port driver
Ⅱ. Hardware Connection
As shown in the figure, use the supplied cable to connect the serial module to Autopilot RX and TX port, black
and brown lines are ground wires, close upwardly to the side of Autopilot LOGO.
In the menu of OSD Settings, go to CTL Control Settings, select “CustomMode” as “WayPoint”, in switching the
waypoint mode (CH5>50%, 30%<CH6<75%).