User Manual

-13-
Ⅴ. Troubleshooting
1. You cannot open the software because it prompts “missing .NET”
Download .NET in Microsoft official website by following the prompt, or directly download it by searching
“.NET3.5” in Google.
2. The data transmission is slowly updated , RSSI is less than 80%
The communication speed is relatively slow when the Autopilot is just powered on; it is recommended to click
on “Communication Setup”, then click “OK” to re-upload the communication parameters, or close the serial port
and reopen it to set up a connection. Or Power on the Autopilot each time before opening the ground station to
maintain the connection at all times.
3. when you open serial module setup software , will display incomplete ( pls see below picture)
This is caused by the operating system text display is too large, Please open “Control Panel” – “Display Options”
–“Enlarge or shrink the text and other items”– set the text size range between " small (S) to 100%" is ok.
Ⅵ. Attention
Please read through carefully:
1. The design purpose of autopilot is to keep balance of flight, it is not able to manipulate plane or prevent stall.
You must have sufficient experiences of fixed wing to control the flight.
2. The autopilot is only for small-scale RC model. For safety concern, please do not install in plane for aerial
photography which might fly over crowd.
3. Please install the autopilot depends on your demands and check the condition before flying every time.
4. Any equipments and electric products on the plane couldn’t be completely reliable, please using this system
following the instruction. The system provider is not responsible for any direct or indirect loss and consequence
caused by using this product.
///////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
For any opinion or suggestion, please send e-mail to [e-mail] and we look forward to listening to
your opinion for the continuous improvement of our product!