User Manual

-19-
to accidents. Test the rudder quantity well when using the flap, keep an eye on the flap/brake control value;
Use the CH7 to control the flap. Add speed control after finishing testing the Flap max/Flap zero.
Butterfly brake
When the Mix (KEY4) is set to “Butterfly FW (Flywing) "mix control. Use four rudder surfaces to control the roll,
pitch, direction and brake (slow down).
Two control surfaces on the left wing. The other two are on the right wing. The four surfaces are connected to
the output places of channel 1, 4, 7, 8 in order.
Turn the aileron stick to the left, then the two surfaces on the left lift up and the two surfaces on the right go
down.
Lower the lifting stick, then the two surfaces on the left lift up and the two surfaces on the right lift up too.
Turn the direction stick to the left, then the outer surface will lift up and the inner surface goes down. There
will be no movement on the right (Increase the resistance on the left, so as to make the flight turn left)
CH7 controls butterfly brake. The outer surface on the left will lift up and the surface on the right goes down.
The outer surface will lift up.
Brake Ctl CH7 (default): CH7 controls the rudder amounts of brake.
InnerBrake Max Inner Brake Max: It is the maximum position at the two control surfaces in inner
side when it brakes (OSD displays F, 100% output brake quantity). When this
item gets into the adjusting, the servos will output the adjusting value, Correct
InnerBrake value can be set according to the rudder position.