User Manual

-11-
6 GPS & Save Home Position
After power on, Arkbird will start to search GPS satellite and save the first valid position as Home.
During searching, the elevator will be up and any manipulation of radio stick is invalid. If need to skip the
searching, please push CH6 more than 75% and push CH1 to left or right side for 1 second.
Once skipped the searching, it CANNOT switch to RTH mode, RTH logo will flash but it is balance mode.
The plane cannot be manipulated when forcible satellite searching
Flight OSD Interface
Attention
1. Only when the camera signal is connected can the OSD work and the AAT function be used; when no
camera connected, the VDSTS yellow LED flashes slowly. Upon receiving, the LED will flash fast.
2. There is AAT modulation module in the Arkbird OSD 2.0. The GPS information is superimposed in the video
signal, and can be downloaded via video TX unit. Together with the ground unit, GPS signal can be directly
identified and tracked. (AAT ground terminal's yellow LED has double flash lights at first. After being
positioned, the yellow LED flashes fast. As there is no audio output, the green LED will not flash). If VDSTS