Operating Instructions AVS-Wireless Receiver-P2 FHD Please read this manual thoroughly before operating the unit, and keep it for future reference. V2.
Contents 1. Precautions ........................................................... 1 2. Product Features ................................................... 3 3. Technical Specifications ........................................ 3 4. Application............................................................. 4 5. Operation Instructions ...........................................
1. Precautions ● Storage and Keeping (1) Do not expose the device to excessive heat or cold. The storage temperature of this device is -30~+80℃,and the operating temperature is -20~+70℃.The humidity is Rh90﹪. (2) Avoid dropping or striking this device. (3) Avoid using this device in enclosed spaces, areas with excessive vibration or subjecting this device to severe impacts. (4) Do not place cables where they may be pinched or stepped on.
● Maintenance Remove all cable connections from the device before cleaning the unit. Caution Risk of electric shock Do not open Caution: to reduce the risk of electric shock, Do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons.
2. Product Features Antenna ″PAIR″ Button 4PIN Female (1) Power supply: DC 24V (2) Metal housing, solid, suitable for outdoor use (3) Waterproof protection level equals to IP69K (4) Indication: Power: the “POWER” indicator turns red when power is on. Pairing: press “PAIR” button for 3 seconds, the “PAIRING” indicator turns blue and flashes. Pairing success: the “PAIRING” indicator turns blue and keeps on. 3.
4. Application 5. Operation Instructions 1. 2. Connect the receiver to the monitor and the monitor should be switched to the receiver channel. When the receiver is powered on, the “POWER” indicator turns red. When powered on, the receiver will always wait for connecting to the transmitter with which it paired before. Press the "PAIR" button for 3 seconds to force the receiver into pairing mode at any time.
3. When the receiver enters pairing mode, the “PAIRING” indicator turns blue and flashes and the receiver will show a picture which indicates pairing. The “PAIRING” indicator will be on always after pairing success, and will turn off if pairing fails. 4. If the receiver does not pair with a transmitter, or if the receiver cannot receive signal from the transmitter, the receiver will display a picture which indicates “LOST LINK”. 5.
6. 7. The video output of the receiver will automatically match the format of the camera which is connected to the transmitter (e.g., if a 1080P camera is connected to the transmitter, the transmitter will output a AHD 1080P video signal). Double-click the "PAIR" button to switch the mirror image.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
