Installation Guide

13
Troubleshooting
Problem
Solution
Checkthattheunitisfullypluggedinto
astandard120Voutlet.
Pressthepowerbuttononthecontrolpanel.
Theunitdoesnotturnon.
Theunitison,butthereisnoameeffect. Openthebackpanelstocheckiftheame
spindlehas fallenofffromthespindlemotor.
Thereisavisibleameeffect,buttheheater
doesnot continuetoblowwarmairafterrepeatedly
turningontheheater.
Turnon/offtheheaterbuttonseveraltimesto
makesure itisinthe“ON”position.
Theheaterdoesnotwork,butthepower
andheaterswitchesareinthe“ON”position.
Turnallswitchestothe“OFF”positionandunplug
the unitfromthewalloutletfor5minutes.
After5minutesplugtheunitbackintothewalloutlet,
andoperateas normal.
Makesurethatnoobjectsareblockingtheair
ventsonthetopandonthefrontofyourreplace.
Changetheremotebattery.
Operateremotetransmitterataslowmeasuredpace.
Presstheremotecontrolbuttonswithanevenmotion
andgentlepressure.
Repeatedlypressingbuttonsinrapidsuccessionmay
causethetransmittertomalfunction.
Standclosertoyourreplace.
Removeobjectsthatmayblockyourremotecontrol's
abilitytocommunicatewithyourreplace.
Remotecontrolisnotworking.