Instructions / Assembly

For 4-Door Installs :
Attach each Fascia to the upper corner of the Track by removing the tape
backing and pushing against track as shown in Figure 20 .
Cut Fascia s if necessary. (Cut with Fascia front up.)
Place Fascia Block over the gap at the center of the opening.
Step 1 0 - Attach The Pull
Attach the Pul l to the inside stile of the
non- pivoting door panel as shown in
Figure 1 . Drill a 3/1 6˝ (5mm) diameter
hole 36˝ from the bottom of the door and
1 1/2˝ from the vertical edge of the st ile
as shown in Figure 1 .
Attach the P ul l with the Mach ine Screw
as sh own in Figure 2 1 b elow.
Note: It is best to drill from the front of the
door to the back.
FIGURE 20
Attach 4-Door
Fascia
FIGURE 21
Attach Pul
- 9 -