Instructions / Assembly

Table Of Contents

Step 1 - Prepare Track for Mounting

Insert components as shown in Figure 2 for 4-Door set or as in Figure 4 for 2-Door

set. The Upper Pivot may need to be loosened in order to attach to the track. If so, loosen

the screw with a Phillips screwdriver and if necessary loosen the bolt with the included

wrench just enough to slide the Upper Pivot onto track .Tighten Upper Pivot with a Philli

ps screwdriver as shown in Figure 5.

For 4-Door set only, replace the

Small Spring with the Long Spring

in the Snugger as shown in Figure 2.

Note: Insert parts before

mounting track to header.

FIGURE 2

4-DOOR

FIGURE 3

Side View

FIGURE 4

2-DOOR

FIGURE 5

Upper Pivot Location

Step 2- Mount Track

Mount Track to header as shown below.

From side to side, center the Track in the

opening. Use 5 EA (max) Long Screws to

mount each track. The Upper Pivot should

be on the pivoting side of the opening.

FIGURE 6

4-DOOR

- 4 -