Installation & Assembly

1 3/16" (30mm)

1/4" (8mm)

Step 8.

Floor-Mounted Door Guide Installation

Position the floor-mounted door guide just outside the opening of the door

frame. Slide the door side-to-side to test for functionality, then mark the

holes with a pencil and pre-drill 1/4" holes. If drilling directly into a concrete

floor, use the provided anchors.

Center to stile

or minimum

of 2" (51 mm)

Center to

H rail or

minimum

of 42"

(106,68 cm)

Step 10.

Door Handle Installation

Position the handle on the outer, pulling side of the door and measure a

minimum of 2” (51 mm) from the outer edge or to the center of the stile

(see picture below). Next measure up 42” (106 cm) from the floor, or

center using the horizontal slat across the middle of the door to find the

handle mounting position.

With your handle centered at your measurement marking, mark both holes

and pre-drill pilot holes 1 1/8” deep before installing the handle. For soft

wood like Pine, the size of drill bit recommended is 1/8”. Secure the handle

using a hand screwdriver.

Note: using an electric powered drill to secure screws may damage the

screw and door.

Step 9.

Stopper Installation

Slide the left and right stoppers onto the track and find the ideal location by

testing the door in both open and closed positions. Using Allen key, tighten

the stoppers into position.

2 3