Owner's Manual

RF Certification Owner’s Manual
903xxxxx
May 18, 2020
With the fob present, set the ignition switch to ignition to
disarm
the system and exit transport mode.
STORAGE AND SERVICE DEPARTMENTS
Long-Term Parking
To maintain arming, store the fob beyond the range of the
antenna. The antenna range is approximately 1.5 m (5 ft).
Have
the fob present before moving
If the motorcycle will not be operated for several months, such
as during the winter season, see AFTER RIDING, Storing
Motorcycle.
Service Departments
When the motorcycle is left at a Harley-Davidson dealer, there
are two options:
1. Leave an assigned fob with the dealer.
2. To maintain possession of the fob, ask the dealer to disable
the system for service (service mode) before leaving
the dealership.
SIREN (IF EQUIPPED)
Chirp Mode
Vehicles with a siren can be set to chirp upon arming and
disarming.
In chirp mode, the siren sounds two chirps when
arming, and a single chirp when disarming.
Chirpless Mode
In chirpless mode, the siren does not chirp on arming or
disarming.
The siren still provides warning chirps and sounds the alarm
if the motorcycle is moved without the fob present.
Switching Modes
Perform the following to switch between chirp and chirpless
modes.
1. With security fob present, set the ignition switch to
IGNITION.
2. When the security lamp turns off, set the ignition switch
to OFF.
3. When the security lamp turns off (but before the turn signals
flash twice), immediately set the ignition switch to
IGNITION.
4. When the security lamp turns off, immediately set the
ignition switch to OFF.
5. When the security lamp turns off (but before the turn signals
flash twice), immediately set the ignition switch to
IGNITION. The system changes mode. The siren chirps
or remains silent accordingly.
Disconnecting Power
To disconnect the battery or remove the main fuse and
prevent
the siren from sounding.
1. Verify that the fob is present.
2. Set the ignition switch
3. Pull the main fuse from its holder or disconnect the battery.
NOTE
Set the ignition switch to OFF before installing main fuse.