Operation Manual

- 7 -
Attention
✔✔
✔✔
✔
1. INTRODUCTION
1.1 Introduction
The TD8403/TD8412 and TD8803/TD8812 diallers are a series of stand-alone alarm communicators. The
diallers are programmed via a CD3008 or compatible keypad. The keypad must always have remote address
position no. 1. The same keypad may be used to operate the CD-control panel or CS350 which is at-
tached to the control panel bus of the dialler. Data entered at the keypad is sent to the control panel until
the dialler recognises an engineer or user code. Thereafter the keystrokes are no longer sent to the
control panel, until the dialler message ‘LEAVE DIALLER’ is terminated by pressing the . -key.
- The dialler user and engineer code must be different from any panel code. In case
equal codes are used, the keypad will not be accessible from keypad 1.
If a control panel, other than the CD Advisor ® range or CS350 is used, the keypad can be removed after
programming.
The latest series of TD800 diallers is based on Aritech’s successful RD62 series. The RD-diallers receive
alarm messages from the control panel in SIA format. For example: BA01 for an burglar alarm in zone 1 or
FA02 for a fire alarm in zone 2. The programming of the TD is therefore based on these events. SIA events
are assigned to a channel in fast format and to a telephone number.
1.2 How to use this manual
This manual describes how the dialler should be installed and programmed. Read through the manual
carefully to obtain the best performance from the dialler.
1.3 Other manuals
• CS350 Installation manual
• Advisor® Programming manual
• RD6203 Programming manual
1.4 Hardware features
• Input / output telephone line
• Eight programmable inputs (no / nc, delayed and event type)
• Bus for control panel and keypad
• Plastic housing
• Plug-in module for voice and audio listen-in (TD8803/TD8812 only)
• Two open collector outputs (TD8803/TD8812 only)
• Circuit for line monitoring / incoming call detection (TD8803/TD8812 only)
1.5 Software features
• 6 central station telephone numbers
• 1 “follow me” number (use with the Voice option)
• 1 number for remote programming
• Programmable pulse / tone dialling
• Six-figure PABX number
• 16 digits per number
• Multiprotocol: SIA, Aritech fast format, CID, voice, Semadigit
• Programmable test call