Operation Manual

- 17 -
✔✔
✔✔
✔
3.5.4 Paging (Semadigit)
Select Message / Event
The event and the message to be sent must be set in the Message / Event table for the Semadigit (max.
message length - 14 characters)
Enter message 1 The message can be entered in the same way as a telephone number..
Enter message 2 As for message 1.
Enter message 3 As for message 1.
Enter message 4 As for message 1.
3.5.5 Voice / Audio listen-in function
Voice or listen-in
Select here whether the module operates as a voice/listen-in or listen--in/sound memory module.
☛ > TD8403/TD8412: only voice option
> TD8803/TD8812: voice/listen-in
• Select Message
At this prompt select a message number for the event..
• Start recording
Start recording the message.
Procedure:
I. Connect a standard telephone to the RJ11 telephone connector on the voice module (see fig. 3).
II. Press Enter . to start recording the message. A counter on the keypad display indicates the number
of seconds of recording time left.
III. Push button PB1 on the voice module to start to record the first message (see fig. 3).
START ... speak into receiver ... STOP REMAINING TIME (seconds)
see display on keypad 1
☛ o & MESSAGE 1 ☛ o 40
☛ o & MESSAGE 2 ☛ o 35
☛ o & MESSAGE 3 ☛ o 30
☛ o & MESSAGE 4 ☛ o 24
☛ o & MESSAGE 5 ☛ o 3
☛ > In total up to 5 messages can be recorded. The fifth message (final text) is
always forwarded automatically after one of the 4 other messages.
> The full recording cycle must always be completed (text 1-5).