Instructions for use WASHING MACHINE Contents GB English,1 PT Português,13 GB Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Description of the washing machine, 4-5 Control panel Display Running a wash cycle, 6 Wash cycles and options, 7 Table of programmes and wash cycles Wash options Detergents and laundry, 8 Detergent dispenser drawer Preparing the laundry Special wash cycles WMG 622 Precautions and advice, 9 General saf
Installation GB ! This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. ! Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Unpacking and levelling Unpacking 1.
! The cable should not be bent or compressed. Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor; GB ! The power supply cable must only be replaced by authorised technicians. Warning! The company shall not be held responsible in the event that these standards are not observed.
Description of the washing machine GB Control panel TEMPERATURE OPTION button buttons and indicator lights ON/OFF CLEANING ACTION button button DISPLAY Detergent dispenser drawer WASH CYCLE SELECTOR KNOB SPIN button CHILD LOCK button START/PAUSE button and indicator light DELAY TIMER button Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”).
Display GB B A C The display is useful when programming the machine and provides a great deal of information. The duration of the available wash cycles and the remaining time of a running cycle appear in section A; if the DELAYED START option has been set, the countdown to the start of the selected wash cycle will appear.
Running a wash cycle GB 1. SWITCH THE MACHINE ON. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. compartment 1. When pouring in the bleach, be careful not to exceed the “max” level marked on the central pivot (see figure pag. 8). 2. LOAD THE LAUNDRY. Open the porthole door. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page.
Wash cycles and options Bleach Fabric softener Max. load (kg) Residual dampness % Energy consumption kWh Total water lt Cycle duration Description of the wash cycle Anti Stain Whites 4 4 6 6 6 3 3 4 4 1,5 1 53 53 53 44 44 - 2,18 0,87 0,86 0,93 0,57 - 75 51 69 47 46 - 180’ 180’ 168’ 150’ 145’ 110’ 95’ 195’ 118’ 72’ 80’ Cotton + Prewash: extremely soiled whites. Cotton (1): heavily soiled whites and resistant colours.
Detergents and laundry GB Detergent dispenser drawer Special wash cycles Successful washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. Anti Stain: the programme 1 is suitable to heavily-soiled garments with resistant colours. It ensures a washing class that is higher than the standard class (A class).
Precautions and tips ! This washing machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only.
Care and maintenance GB Cutting off the water and electricity supplies Caring for the door and drum of your appliance • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washing machine and help to prevent leaks. • Always leave the porthole door ajar in order to prevent unpleasant odours from forming. • Unplug the washing machine when cleaning it and during all maintenance work.
Troubleshooting Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”), make sure that the problem cannot be not solved easily using the following list. Problem: Possible causes / Solutions: The washing machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. GB • There is no power in the house. The wash cycle does not start.
Service GB Before contacting the Technical Assistance Service: • Check whether you can solve the problem alone (see “Troubleshooting”); • Restart the wash cycle to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre. ! Always request the assistance of authorised technicians. Have the following information to hand: • the type of problem; • the appliance model (Mod.); • the serial number (S/N).
Instruções para a utilização MÁQUINA DE LAVAR ROUPA Sumário PT Português PT Instalação, 14-15 Desembalar e nivelar Ligações hidráulicas e eléctricas Primeiro ciclo de lavagem Dados técnicos Descrição da máquina de lavar roupa, 16-17 Painel de comandos Visor Como efectuar um ciclo de lavagem, 18 Programas e opções, 19 Tabela dos programas Opções de Lavagem WMG 622 Detergentes e roupa, 20 Gaveta dos detergentes Preparar a roupa Programas especiais Precauções e conselhos, 21 Segurança geral Eliminação A
Instalação PT ! É importante guardar este livrete para poder consultá-lo a qualquer momento. Se a máquina for vendida, cedida ou transferida, certifique-se que este livrete permaneça com a máquina para informar o novo proprietário acerca do seu funcionamento e das respectivas advertências. ! Leia com atenção estas instruções: há importantes informações acerca da instalação, da utilização e da segurança. Desembalar e nivelar Desembalar 1. Tire a máquina de lavar roupa da embalagem. 2.
Ligação do tubo de descarga 65 - 100 cm Ligue o tubo de descarga, sem dobrá-lo, a uma conduta de descarga ou a uma descarga na parede situada entre 65 e 100 cm de altura do chão; ! O cabo não deve ser dobrado nem apertado. PT ! O cabo de alimentação deve ser substituído somente por técnicos autorizados. Atenção! O fabricante declina toda a responsabilidade se estas regras não forem respeitadas.
Descrição da máquina de lavar roupa PT Painel de comandos Teclase indicadores luminosos de Tecla da Tecla ON/OFF TEMPERATURA OPÇÃO Tecla INTENSIDADE LAVAGEM Visor Selector de Tecla PROGRAMAS Gaveta dos detergentes Tecla CENTRIFUGAÇÃO Tecla e indicador luminoso BLOQUEIO START/PAUSE DAS TECLAS Tecla INÍCIO POSTERIOR Gaveta dos detergentes: para colocar detergentes e aditivos (veja “Detergentes e roupa”). Tecla ON/OFF : carregue brevemente na tecla para ligar ou desligar a máquina.
Visor PT B A C O visor é útil para programar a máquina e fornece muitas informações. Na secção A é visualizada a duração dos vários programas à disposição e com o ciclo iniciado o tempo restante para o fim do mesmo; no caso em que tenha sido programado um INÍCIO POSTERIOR, será visualizado o tempo Restante para o início do programa seleccionado.
Como efectuar um ciclo de lavagem PT 1. LIGAR A MÁQUINA. Carregue na tecla ; o indicador luminoso START/PAUSE piscará lentamente na cor verde. 2. COLOCAR A ROUPA Abrir a porta de vidro. Coloque a roupa dentro da máquina prestando atenção para não superar a carga máxima indicada na tabela dos programas na página seguinte. 3. DOSAGEM DO DETERGENTE.Extrair a gaveta e deitar o detergente nos específicos recipientes como explicado no parágrafo “Detergentes e roupa”. 4. FECHAR A PORTA DE VIDRO. 5.
Programas e opções Tabela dos programas 1200 - - 12 Algodão água fria 1200 - 13 Sintéticos água fria água fria 800 Enxaguamentos Centrifugação e Descarga Algodão (2-3): brancos e coloridos delicados pouco sujos. Sintéticos Resistentes: coloridos resistentes muito sujos. Sintéticos Resistentes (4): coloridos resistentes muito sujos. Anti-alérgico Bebé Lã: para lã, cashmere, etc.
Detergentes e roupa PT Gaveta dos detergentes Programas especiais O bom resultado da lavagem depende também do emprego da dose certa de detergente: com excessos não se lava de maneira mais eficaz, mas contribui-se para formar crostas nas peças internas da máquina de lavar roupa e poluir o meio ambiente. Antimanchas: o programa 1 é adequado à lavagem de peças muito sujas com cores resistentes. O programa garante uma classe de lavagem superior à classe padrão (classe A).
Precauções e conselhos ! Esta máquina de lavar roupa foi projectada e fabricada em conformidade com os regulamentos internacionais de segurança. Estas advertências são fornecidas por razões de segurança e devem ser lidas com atenção. Segurança geral • Este aparelho foi projectado exclusivamente para um uso doméstico.
Manutenção e cuidados PT Interromper a alimentação de água e de corrente eléctrica • Feche a torneira da água depois de cada lavagem. Desta maneira diminuiu-se o desgaste do sistema hidráulico da máquina de lavar roupa e elimina-se o risco de inundação. • Tire a ficha da tomada eléctrica quando for limpar a máquina de lavar roupa e durante os trabalhos de manutenção. Limpar a máquina de lavar roupa • A parte externa e as peças em borracha podem ser limpas com um pano molhado com água morna e sabão.
Anomalias e soluções Pode acontecer que a máquina de lavar roupa não funcione. Antes de telefonar para a Assistência Técnica (veja “Assistência”), verifique se não se trata de um problema fácil de resolver com ajuda da seguinte lista. Anomalias: PT Possíveis causas / Solução: A máquina de lavar roupa não liga. • A ficha não está colocada na tomada eléctrica, ou não o suficiente para haver contacto. • Em casa não há corrente. O ciclo de lavagem não inicia.
Assistência 195095041.01 12/2011 - Xerox Fabriano PT Antes de contactar a Assistência Técnica: • Verifique se consegue resolver a anomalia sozinho (veja “Anomalias e soluções”); • Reinicie o programa para verificar se o inconveniente foi resolvido; • Em caso negativo, contacte um Centro de Assistência Técnica. ! Nunca recorra a técnicos não autorizados. Comunique: • o tipo de anomalia; • o modelo da máquina (Mod.