User Manual
Table Of Contents
- For your safety
- WARNINGS
- THE APPLIANCE
- TH 721 D22 B/NG TH 7
- TH 721 D22 B/NG TH 7
- TH 721 D22 E/LPG TH 7
- TH 721 D22 E/NG TH 7
- TH 721 D22 E/NG TH 7
- TH 931 D2/A B/LPG TH 931 D2/A E/LPG
- TH 931 D2/A B/NG TH 931 D2/A E/NG
- TH 931 D2/A B/TG TH 931 D2/A E/TG
- DESCRIPTION OF THE APPLIANCE
- The detailed differences between the models are li
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/TG TH 931
- TH 731 D2/A B/NG TH 931
- TH 731 D2/A B/TG TH 931
- TH 731 D2/A E/LPG TH 931
- TH 731 D2/A E/NG
- TH 731 D2/A E/TG
- There should be at least 170mm between top and the
- General safety
- CLEANING and MAINTENANCE
- PRACTICAL TIPS
- FAQ and TROBULE SHOOTING
- Blank Page
- Blank Page
FAQs Possible Reasons Solutions
The burner has
wobbled and not
sitting properly
Burner not aligned properly leading to
wobbling and deterioration
1. Replace the burner
2. Follow the
instructions on page
12 & 13
Ignition issue 1. Ignition not getting activated
2. Gas not flowing
3. Battery need replacement
1. Users must press the
knob (>5 seconds) down
enough to activate the
micro switch which
would ignite the igniter
2. Turning the knob
would allow the gas to
flow and combustion to
take place
3. Ensure the igniter and
thermocouple are clean
4. Change battery
Flame
cannot hold
1. Thermocouple not sensing heat and
gas supply is shut off
2. Wobbled burner not allowing
thermocouple to sense heat
3. Misaligned burner
4. Thermocouple is defective
5. User not pressing the knob long
enough
1. Align the burner
correctly
2. Ensure the inner cap,
outer cap and burner
are free from food
particles
3. Press the knob more
than 5 seconds
Popping sound
1. Misaligned burner
2. Wobbled burner
Users must ensure that
the outer cap is properly
placed and aligned with
the arrow mark on the
burner
19
FAQ and TROBULE SHOOTING