User Manual
Table Of Contents
- For your safety
- WARNINGS
- THE APPLIANCE
- TH 721 D22 B/NG TH 7
- TH 721 D22 B/NG TH 7
- TH 721 D22 E/LPG TH 7
- TH 721 D22 E/NG TH 7
- TH 721 D22 E/NG TH 7
- TH 931 D2/A B/LPG TH 931 D2/A E/LPG
- TH 931 D2/A B/NG TH 931 D2/A E/NG
- TH 931 D2/A B/TG TH 931 D2/A E/TG
- DESCRIPTION OF THE APPLIANCE
- The detailed differences between the models are li
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/TG TH 931
- TH 731 D2/A B/NG TH 931
- TH 731 D2/A B/TG TH 931
- TH 731 D2/A E/LPG TH 931
- TH 731 D2/A E/NG
- TH 731 D2/A E/TG
- There should be at least 170mm between top and the
- General safety
- CLEANING and MAINTENANCE
- PRACTICAL TIPS
- FAQ and TROBULE SHOOTING
- Blank Page
- Blank Page
12
Check the Seal
Once the appliance have been installed, make sure all the connections are properly sealed,
using a soapy water solution. Never use a flame.
a) Prior to installation, ensure that the local distribution conditions (nature of the gas
and gas
pressure) and the adjustment of the appliance are compatible
b) The adjustment conditions for this appliance are stated on the label (or data plate)
c) This appliance is not connected to a combustion products evacuation device. It shall be
installed and connected in accordance with current installation regulations. Particular attention
shall be given to the relevant requirements regarding ventilation.
CAUTION: In case of cook top glass breakage: shut immediately off all burners and any
electrical heating element and isolate the appliance from the gas supply do not touch the
appliance surface, do not use
the appliance.
The appliance shall not be operated for more than 15 s. If after 15 s the burner has not lit, stop
operating the device and open the compartment door and/or wait at least 1 min before
attempting a further ignition of the burner.
In the event of the burner flames being accidentally extinguished, turn off the burner control and
do not attempt to re-ignite the burner for at least 1 min.
Important Instructions:
• How to remove the burner, outer
cap and inner cap and reinstall correctly?
The burner has 3 components
A - Inner cap
B - Burner
C - Outer cap