User Manual
Table Of Contents
- For your safety
- WARNINGS
- THE APPLIANCE
- TH 721 D22 B/NG TH 7
- TH 721 D22 B/NG TH 7
- TH 721 D22 E/LPG TH 7
- TH 721 D22 E/NG TH 7
- TH 721 D22 E/NG TH 7
- TH 931 D2/A B/LPG TH 931 D2/A E/LPG
- TH 931 D2/A B/NG TH 931 D2/A E/NG
- TH 931 D2/A B/TG TH 931 D2/A E/TG
- DESCRIPTION OF THE APPLIANCE
- The detailed differences between the models are li
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/TG TH 931
- TH 731 D2/A B/NG TH 931
- TH 731 D2/A B/TG TH 931
- TH 731 D2/A E/LPG TH 931
- TH 731 D2/A E/NG
- TH 731 D2/A E/TG
- There should be at least 170mm between top and the
- General safety
- CLEANING and MAINTENANCE
- PRACTICAL TIPS
- FAQ and TROBULE SHOOTING
- Blank Page
- Blank Page
11
Gas Connection for Cooktop
The cooktop should be connected to the gas supply by an authorized installer. During
installation of this product it is essential to fit an approved gas tap to isolate the supply from the
appliance for the convenience of any subsequent removal or servicing. Connection of the
appliance to the gas mains or liquid gas tanks must be carried out according to the safety
standards currently in force, and only after it is ascertained that it is suitable for the type of gas
to be used. If not, follow the instructions indicated in the section entitled, “Adapting the cooktop
for Different Types of Gas”. If the cooktop is to be connected to tanks containing liquid gas, use
pressure regulators that comply with current safety standards.
Important: To insure that the appliance operates safety, the gas is regulated correctly and
your appliance lasts overtime, make sure that gas pressure levels comply with the indications
given , “Nozzle and Burner Specifications”.
Gas connection to Non-flexible Pipe
(Copper or Steel)
Connection to the gas source must be done in such a way as to not create any stress points at
any part of the appliance.
The appliance is fitted with an adjustable, “L” shaped connector and a gasket for the
attachment to the gas supply. Should this connector have to be turned.
The gasket must be replaced (supplied with the appliance).
The gas feed connector to the appliance is a threaded, male 1/2” connector for round gas pipe.
Gas Connection to Flexible Steel Pipe
The gas feed connector to the appliance is a threaded, male 1/2” connector for round gas pipe.
Only use pipes, tubes and gaskets that comply with current safety codes. The maximum length
of the flexible pipes must not exceed 2000 mm. Once the connection have been made, ensure
that the flexible metal tube does not touch any moving parts and not crushed.