User Manual
Table Of Contents
- For your safety
- WARNINGS
- THE APPLIANCE
- TH 721 D22 B/NG TH 7
- TH 721 D22 B/NG TH 7
- TH 721 D22 E/LPG TH 7
- TH 721 D22 E/NG TH 7
- TH 721 D22 E/NG TH 7
- TH 931 D2/A B/LPG TH 931 D2/A E/LPG
- TH 931 D2/A B/NG TH 931 D2/A E/NG
- TH 931 D2/A B/TG TH 931 D2/A E/TG
- DESCRIPTION OF THE APPLIANCE
- The detailed differences between the models are li
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/LPG TH 931
- TH 721 D22 B/TG TH 931
- TH 731 D2/A B/NG TH 931
- TH 731 D2/A B/TG TH 931
- TH 731 D2/A E/LPG TH 931
- TH 731 D2/A E/NG
- TH 731 D2/A E/TG
- There should be at least 170mm between top and the
- General safety
- CLEANING and MAINTENANCE
- PRACTICAL TIPS
- FAQ and TROBULE SHOOTING
- Blank Page
- Blank Page
10
The cooktop can also be installed above built-in ovens provided with cooling ventilation.
In the event the cooktop is installed above a built-in oven, a wood panel must be inserted as
insulation. This panel must be placed at about 50 mm from the bottom of the cooktop itself.
Important: When installing the cooktop above a built-in oven, the oven should be placed on
two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at
least 45 x 560 mm at the back.
Installation of Built-In Cooktops on a CYLINDER COMPARTMENT
In the event the cooktop is installed above cylinder compartment, a wood panel must be
inserted as insulation. This panel must be placed at about 50 mm from the bottom of the
cooktop itself.
The opening of this compartment have to permit the easy introduction and removal of the
cylinder. The dimension of the opening and the inside of the compartment shall be at least
large enough to accommodate the cylinders (with regulator fitted) which are the most
commonly used in the country. The total area of the opening in the upper part shall be at least
1/100 of the floor area of the compartment. The total area of the openings of the base shall be
at least 1/50 of the floor area of the compartment. The cylinder support:
Shall have sufficient mechanical strength.
Shall not let the cylinder rest directly in the ground.
Shall not sill higher than the base on which the cylinder rests.
The cylinder tap have to be readily accessible.
Overflow of liquid from pans of the hotplate shall not fall onto cylinder or its accessories.
The flexible tube shall not be in contact with sharp edges. No internal communication shall
exist between the cylinder compartment and the different parts of the appliance where burners
are placed.
The ventilation openings of the compartment cannot be obstructed when the appliance is
placed in position.