Operating Instructions HOB Contents GB English,1 PT FR Français, 13 AR Português, 40 ES Español, 27 Installation, 2-5 Positioning Electrical connection Gas connection Data plate Burner and nozzle specifications Description of the appliance, 6 Overall view Start-up and use, 7-9 Practical Practical Practical Practical Module PH 930MST PH 940MST PH 941MS PH 941MSTB PH 941MSTB GH PH 941MSTV PH 941MSTV GH PH 960MST PH 960MST GH advice on using the burners Advice on Using the Electric Hot Plates Advise
Installation ! Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. also be equipped with vents to allow gas to escape in the event of a leak. As a result LPG cylinders, whether partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level (cellars, etc.).
Front Hooking position for top H=40 mm Connecting the supply cable to the mains Back ! Use the hooks contained in the “accessory pack” • Where the hob is not installed over a built-in oven, a wooden panel must be installed as insulation. This must be placed at a minimum distance of 20 mm from the lower part of the hob. Ventilation To ensure adequate ventilation, the back panel of the cabinet must be removed.
GB Connection with a rigid pipe (copper or steel) ! Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L -shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). The gas supply pipe fitting is a threaded 1/2 gas cylindrical male attachment.
Burner and nozzle specifications GB Table 1 Liquid Gas Diameter (mm) Burner Thermal Power kW (p.c.s.*) Nom. Red. By-pass 1/100 (mm) Naturale Gas Nozzle 1/100 Flow* g/h Nozzle 1/100 (1) (mm) *** ** (mm) Flow* l/h Fast (Large) (R) 100 3.00 0.70 41 39 86 218 214 116 286 Reduced Fast (RR) 100 2.60 0.70 41 39 80 189 186 110 248 Semi Fast (Medium) (S) 75 1.65 0.40 30 28 64 120 118 96 157 Auxiliary (Small) (A) 55 1.00 0.
Description of the appliance GB Overall view Support Grid for COOKWARE GAS BURNERS Ignition Button for GAS BURNERS * 1 6 2 5 4 Control Knobs for GAS BURNERS and ELECTRIC HOTPLATES * ELECTRIC HOT PLATES * / COOKTOP BROILER * / CERAMIC GLASS MODULE * SAFETY DEVICES * • The INDICATOR LIGHT FOR ELECTRIC HOTPLATES / COOKTOP BROILER / CERAMIC GLASS MODULE * switches on whenever the selector knob is moved from the ‘off’ position.
Start-up and use ! The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: • A. Circular heating zone; B.Extended heating zone; C.Indicator light to show when the cooking zone is above 60°C, even after the heating element has been turned off.
GB Practical Advice on Using the Half Fish-Kettle Burner * The two "Half Fish-Kettle" burners, are eliptic in form and can be turned up to 90°. This makes the cooktop more flexible in terms of how it can be used. To turn the two central burners 90°, proceed as follows: • Make sure that the burners are cool; • Lift the burner completely out of its housing; • Replace it in its housing in the position desired; • Make sure that the burners are positioned correctly before use.
Practical Advise on Using the Ceramic Glass Module* Set. Radiant Burner 0 Off. 1 To melt butter and chocolate. To obtain the best results from your hob: GB • Use flat-bottomed pans to ensure that they adhere to the cooking zone perfectly. 2 To heat liquids. 3 4 For creams and sauces. 5 • Always use pans with a diameter that is large enough to cover the hotplate fully, in order to use all the available heat. 6 For cooking at the boiling point. 7 8 For Roasts. 9 10 For boiling large pieces of meat.
Precautions and tips GB ! This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. General safety • This is a class 3 built-in appliance. • Gas appliances require regular air exchange to maintain efficient operation. When installing the hob, follow the instructions provided in the paragraph on “Positioning” the appliance.
Maintenance and care Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Cleaning the appliance ! Do not use abrasive or corrosive detergents such as stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. ! Never use steam cleaners or pressure cleaners on the appliance.
Troubleshooting GB It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. Problem Possible causes/Solution The burner does not light or the flame is not even around the burner. • The gas holes on the burner are clogged.
تعليمات التشغيل 07/2010 - 195085649.
