NIV 320B lnduction Hob Instruction Manual 1
CONTENTS 2 IMPORTANT SAFETY INSTRUCTIONS p.3-4 SAFEGUARDING THE ENVIRONMENT p.5 BEFORE USE p.5 COOKWARE p.5 INSTALLATION p.6-7 ELECTRICAL CONNECTION p.8 PRODUCT DESCRIPTION p.9 CONTROL PANEL DESCRIPTION p.9 INSTRUCTIONS FOR USE p.10-13 CLEANING p.14 TROUBLESHOOTING p.15 GUIDE POWER LEVEL TABLE p.16 TECHNICAL SPECIFICATIONS p.
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED Before using the appliance, read these safety instructions. Keep them nearby for future reference. These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or incorrect setting of controls. WARNING: The appliance and its accessible parts become hot during use.
Do not use extension leads, multiple sockets or adapters. The electrical components must not be accessible to the user after installation. Do not use the appliance when you are wet or barefoot. Do not operate this appliance if it has a damaged power cable or plug, if it is not working properly, or if it has been damaged or dropped.
TO MAINTAIN THE EFFICIENCY AND SAFETY OF YOUR APPLIANCE, WE RECOMMEND YOU ALWAYS USE ORIGINAL SPARE PARTS AND TO CALL ONLY OUR AUTHORIZED SERVICE AGENTS IN CASE OF NEED. BEFORE USE IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION SYSTEM”. Place the pot on the required cooking zone before switching the hob on. COOKWARE - Use thick cookware with flat and smooth bottom.
INSTALLATION After unpacking the product, check for any damage during transport. In the event of problems, contact the dealer or the After-Sales Service. - The electrical connection of this hob must be carried out by qualified technician, according to the instructions in this user manual and in compliance with the local regulations. In the event of any damage that occurs as a result of improper connection or installation, the warranty will not be valid. - This appliance must be earthed.
3. Secure the hob in place by putting it into cutout on the work surface. When installed above oven, it is necessary to remove the rear kitchen element panel in the area of the oven opening, in order to supply ventilation. Also, the front part of the kitchen element must have an opening of no less than 5 mm tall. W (mm) 290 min. A (mm) 50 D (mm) 520 min. B (mm) 50 H (mm) 56 E (mm) 100 C1 (mm) 270 min.
ELECTRICAL CONNECTION - Disconnect the appliance from the power supply. - Installation must be carried out by qualified personnel who know the current safety and installation regulations. - The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. - The power cable must be positioned away from direct heat sources and long enough to allow the hob to be removed from the worktop.
PRODUCT DESCRIPTION Induction heating element Control panel CONTROL PANEL DESCRIPTION 9
INSTRUCTIONS FOR USE - Use the induction cooking zones with suitable cookware. - After mains voltage is applied, all displays are on for a moment. When this time is over, the hob is in the standby mode and it is ready for operation. - The hob is controlled with electronic sensors which are operated by touching the related sensors. Each sensor activate is followed by a sound signal (buzzer).
Switching the cooking-zones OFF Select the cooking zone to be switched off by pressing the button. Press the button to set the level to “0”. The cooking zone can also be switched off by pressing the and buttons at the same time. The cooking zone switches off and the residual heat indicator “H” lights up. If the cooking zone is hot, “H” will be lighted up instead of “0”. Booster function A cooking zone has to be selected, cooking level set to “desired cooking level” and press button.
LOCKED will appear in all displays and the control panel is locked. (If a cooking zone is in hot condition,“L”and “H”will be displayed in alternation.) The hob will remain in a locked condition, even if the control panel has been switched off and on. To deactivate the child lock, first switch on the hob, press the simultaneously and then press the and buttons button. “L”will disappear in the display and the hob will be switched off.
between 0 to 99 minutes. If there is no operation in 10 seconds, the minute minder will be sent and the blinking dot will disappear. Once the set time has elapsed, an acoustic signal sounds and the display blinks and timer begins the countdown. Acoustic signal will sounds for 30 seconds or be stopped by pressing any button. The minute minder can be changed or switched off any time by pressing Switching off the hob by pressing or button. button at any will also switch off the minute minder.
CLEANING - Do not use steam cleaners. - Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator“H”is not displayed. IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass. - After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals. - Sugar or foods with a high sugar content damage the hob and must be immediately removed.
TROUBLESHOOTING GUIDE - Read and follow the instructions given in the section “SAFETY INSTRUCTIONS”. - Make sure there is not a power outage. - Dry the hob thoroughly after cleaning it. - If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions. - If the hob cannot be switched off after using it, disconnect it from the power supply. If there is an error, error code will be showed at the heater displays.
POWER LEVEL TABLE The information given in below table is for reference. Power level Type of cooking Level use (Indicating cooking experience and habits) Ideal for rapidly increasing the temperature of food to Boost Fast heating fast boiling in the case of water or rapidly heating cooking liquids Max.
TECHNICAL SPECIFICATIONS Brand NIV 320B Model Type of Hob Number of Cooking Zones Heating Technology-1 Size-1 Energy Consumption-1 Heating Technology-2 Size-2 Energy Consumption-2 Energy Consumption of Hob cm Wh/kg Wh/kg Electric 2 Induction Ø16,0 189,0 Induction Ø20,0 189,0 189,0 Rated Voltage V 220 - 240 Rated Frequency Hz 50 - 60 Power Consumption W 3600 Plug cm Wh/kg No plug This hob complies with EN 60350-2 17 52202510
