Operation Manual

GB
21
Next, press the key to set the minutes and
save using key.
! Attention: if the on and off times coincide, the
machine ignores both settings. The clock must be
enabled after this programming in order to function
correctly.
To enable automatic on/off
! Note: this function is enabled only if automatic on/off
time is been programmed.
Use the key to select this function:
AUTOMATIC ON/OFF *
CLOCK TIME
Enable it with the key.
AUTOMATIC ON/OFF
NO
In this case disables this function.
Enable the function with the key and when the
display shows
AUTOMATIC ON/OFF
YES
save using the key.
Check the parameter settings when exiting
programming. If the current time falls within the
disabled period the display shows:
STANDBY
! Note: during the disabled phase the machine may
be reactivated at any time by pressing the key. To
disable the machine again, go into programming by
pressing and exit immediately by pressing the
key.
WASHING CYCLE
This function performs a washing cycle using water to
clean all components involved in brewing coffee.
! A person should be present during the washing cycle
to supervise the operation. Before performing the
washing cycle fill the water tank.
Use the key to select this function:
RINSING CYCLE *
FACTORY SETTINGS
Press the key.
The display will show:
RINSING CYCLE
NO
Use the key to select
RINSING CYCLE
YES
Press the key to start the washing cycle. The
display shows:
RINSING CYCLE
The machine dispenses about half the quantity of
water contained in the tank from the brew unit.
Then the cycle stops automatically, and the display
shows:
SELECT PRODUCT
READY FOR USE