Operation Manual

15GB

required to hook up the canopy. Small adjustments can be made using the hood adjustment

screws (see Fitting the canopy). The hood should have a maximum excursion of 20 mm.

• Splashback (optional)

When a splashback is to be fitted, the distance between the hood and the cooking

appliances will be determined by the height of the splashback

B and whether or not there

is a raised back on the worktop. The splashback is to be installed before installing the

canopy. If the splashback is to be fixed to the wall using both the top and bottom fixing

holes, care must be taken to ensure that the splashback is fitted at the correct height

before fixing the base units or at least the worktop covering them. As this is a complex

operation, it should only be undertaken by the technician installing the kitchen units or by

a competent person who knows the final dimensions of the units. If the splashback is to

be fixed through the top fixing holes only, proceed as follows:

a) Rest the splashback on the worktop and against the wall, as illustrated in fig.2 .

b) Mark the centres of the two holes in the top surface.

c) Drill the wall using an 8 mm drill bit, and fix the splashback using the rawl plugs and

screws provided.

d) If necessary, the installer should secure the splashback to the wall by tucking the bottom

edge down behind the rear of the worktop.

Fixing the canopy

Before starting to fix the canopy it will be necessary to adjust

the support brackets S1 by turning the adjustment screws in a

clockwise direction until their reach their limit (Fig.3):

a) Hook the canopy onto the two size 4.2 x 44.4 screws 1 fitted

as described above (Fig.4 ).

b) Level the hood by turning the adjustment screws and then

locking them.

Electrical connection and working test

• Before connecting to the mains supply ensure that the mains

voltage corresponds with the voltage on the rating plate inside

the hood.

• Connect the cooker hood to the mains via a double pole

switch which has 3 mm clearance between the contacts.

• The appliance must be earthed.

• Once the electrical connection has been completed, check

that worktop illumination, motor and speed work properly.

Fig. 3

Fig. 4