Technical information

56
18.6.16 Removing the tank
1. Remove the casing as in steps 18.2.1 and 18.2.2;
2. Remove all clips, nuts (No. 30 spanner) and eletrical connections (NTC) from the tank (see Fig. 18.86 & 18.87);
3. Remove the clip on the bottom of the boiler to disengage the pipe between the chassis and the thermal valve (see Fig. 18.88);
4. Disconnect the D.H.W expansion vessel from the left hydraulic block (see Fig. 18.80);
5. Remove the two screws V on the left side panel (see Fig. 18.89);
6
.
R
emove the nut (No. 10 spanner ) on the top of the tank
(
see Fig. 18.90)
;
7
.
P
ull up the tank to disengage it, and then toward you to remove it.
8
.
R
eassemble in reverse order
F
ig. 18.87
Fig. 18.90
Fig. 18.88
F
ig.18. 86
Fig. 18.89
V