Technical data
GB
3
Technical details
Model
ECOT7F 1291
Dimensions
40 cm wide
85 cm high 
60 cm deep
Capacity
from 1 to 7 kg
Electric 
connections
Please  refer to the technical 
data plate fixed to the machine.
Water 
connections
maximum  pressure  1  MPa 
(10 bar) 
minimum pressure 0.05 MPa 
(0.5 bar) 
drum capacity 42 litres
Spin speed
up to 1200 rpm
Test wash 
cycles in 
accordan-
ce with 
directives 
1061/2010 
and 
1015/2010
Programme 2: 
Cotton standard 60°C.
Programme 3: 
Cotton standard 40°C.
This appliance is compliant 
with the following European 
Community Directives: 
- 2004/108/CE (Electroma-
gnetic Compatibility)
- 2006/95/CE (Low Voltage)
- 2002/96/CE
Connecting the drain hose
Connect the drain 
hose, without bending 
it, to a drainage duct 
or a wall drain located 
at a height between 
65 and 100 cm from 
the floor; 
alternatively, rest it on 
the side of a washba-
sin or bathtub, faste-
ning the duct sup-
plied to the tap (see 
figure). The free end 
of the hose should 
not be underwater.
! We advise against the use of hose extensions; 
if it is absolutely necessary, the extension must 
have the same diameter as the original hose and 
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity 
socket, make sure that: 
• the  socket  is  earthed  and  complies  with  all 
applicable laws;
• the socket is able to withstand the maximum 
power load of the appliance as indicated in the 
Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see 
opposite);
• the socket is compatible with the plug of the 
washing machine. If this is not the case, repla-
ce the socket or the plug.
!  The  washing  machine  must  not  be  installed 
outdoors, even in covered areas. It is extremely 
dangerous to  leave  the  appliance  exposed  to 
rain, storms and other weather conditions.
! When the washing machine has been installed, 
the electricity socket must be within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced 
by authorised technicians.
Warning! The company shall not be held respon-
sible in the event that these regulations are not 
respected.
The first wash cycle
Once  the  appliance  has  been  installed,  and 
before you use it for the first time, run a wash 
cycle with detergent and no laundry, using the 
wash cycle 2.
65 - 100 cm










