DEOS 21s UK MANUAL
°C
PURE TURBO MODE POWERTIMER
SET
ON OFF
A
125 467 3
GB
/ 25
CONTROL PANEL
1. POWER BUTTON
Press to switch the dehumidier on and o.
2. MODE BUTTON
Press to select the desired operating mode: STANDARD, SUPER LAUNDRY ROOM, CONTINUOUS or AUTO.
SET
, STANDARD mode - the dehumidier runs until it reaches its humidity setting.
, SUPER LAUNDRY ROOM mode, the dehumidier automatically sets the fan speed and relative humidity in relation
to the ambient temperature. The mode remains active up to 10h.
NOTE: in this mode you cannot change the fan speed or relative humidity settings.
, CONTINUOUS mode, the dehumidier runs at maximum power without time limit.
, AUTO mode, the dehumidier sets the relative humidity in relation to the ambient temperature to maximise occupant
comfort, according to the following rules:
Detected room temperature Set relative humidity
T ≤ 18 °C 55%
18 °C < T < 25 °C 50%
T ≥ 25 °C 45%
NOTE: in this mode you cannot change the relative humidity setting.
On net models, press the MODE button for 3 seconds to initiate the Wireless connection mode. The LED
DISPLAY shows AP for 8 min to indicate you can set Wireless connection.
3.
HUMIDITY SETTING/TEMPERATURE DISPLAY
HUMIDITY SETTING
The relative humidity level can be set from 35% (minimum) and 80% (maximum), with 5% increments each time the ‘+’ and
‘-’ control buttons are pressed. When the set humidity level is reached, the compressor stops
NOTE: the humidity setting buttons are disabled in SUPER LAUNDRY ROOM, CONTINUOUS and AUTO modes.
TEMPERATURE DISPLAY
You can display the ambient temperature (°C) by holding down the “+” button for more than 3 seconds. You can do this
whether the dehumidier is running or not, so long as it is connected to its power supply. The ambient temperature dis-
plays for 10 seconds.
4.
LCD DISPLAY
The display shows the operating mode, actual and set relative humidity, ambient temperature, fan speed, timer, special
functions and shutdown alarms.
When the dehumidier is connected to its power supply, the actual relative humidity displays; to display the ambient
temperature, hold down the “+” button for more than 3 seconds.
5.
TIMER BUTTON
Pressing this button programs a delay after which the dehumidier will start or stop. When set, the TIMER ON / TIMER
OFF icon displays. Press or hold the “+” and “-” control buttons to set the delay: in 0.5 h (30 min) increments for 0-10
hours, and 1h (60 min) increments for 10-24 hours.
Set the delay to 0.0h to cancel the TIMER ON / TIMER OFF function.
NOTE: You can set the TIMER whether the dehumidier is running or not, so long as it is connected to its power supply.