DEOS 16s UK MANUAL

24
GB
CONTROL PANEL
ON/OFF BUTTON
1.
2.
Press to switch the dehumidifier on and off. The indicator light of the ON/OFF button remains lit when the appliance i
functioning and unlit when the appliance is off
MODE BUTTON
Press to select the desired operating mode: STANDARD,CONTINUOUS, AUTO or LAUNDRY.
STANDARD MODE: the appliance functions until the desired humidity level is reached.
CONTINUOUS MODE: the appliance functions at the maximum dehumidification level until the tank fills u In this mode, the ‘+’ and ‘’
control buttons are not enabled (‘cont’ indicator on).
AUTO MODE: the dehumidifier sets the relative humidity ( in a comfortable range 45%-55%) in relation to the ambient temperature
to maximise occupant comfort. In this mode humidity setting buttons are not enabled ('smd' indicator on).
LAUNDRY MODES: The dehumidifier sets the fan speed to high. In this mode, the '+' and 'control' buttons are not enables ('Dryer'
indicator light on).
The desired relative humidity level can be set to between 35% (minimum) and 80% (maximum), with 5% increments each
time the ‘+’ and ‘-’ control buttons are pressed. When the set humidity level is reached, the compressor stops. The humidity
setting buttons are disabled in the continuous and auto mode.
3/4. HUMIDITY SETTING BUTTONS
5. FAN button
Press to select fan speed in three steps-low, med and high. The fan speed indicator light illuminates under different
Press to set the start delay when the appliance is of, or the switch-off delay when it is on. The indicator light to the left of
fanspeed settings, when select high fan speed, both the low and med fan speed lights illuminate.
6. TIMER button
the timer button will light up.
Press or hold the ‘+’ and ‘-’ control buttons to set the desired delay: 30 min (0.5 hours) increments occur between 0 and
10 hours, and 1-hour increments between 10 and 24 hours.
Restore the delay to 0.0 or switch off the appliance to cancel the timer functio.
7. DISPLAY
8. WIRELESS button (available only on NET models)
Press the WIRELESS pad for 3 seconds to initiate the Wireless connection mode. The LED DISPLAY shows AP for 8 min to indi-
cate you can set Wireless connection.
AUTO-RESTART
This function enables the dehumidifier to restart, after a blackout, from the last stored settings.
ANTI-FROST FUNCTION
Prevents the evaporator from frosting, thereby extending the dehumidifier’s life and enhancing energy saving. When this function is ac-
tive, the fan continues to turn while the compressor stops.
TANK FULL STOPPAGE
The dehumidifier stops when the condensate collection tank is full or incorrectly positioned. ‘P2’ will appear on the display
and the ‘full’ indicator light turns on.
IMPORTANT: When the compressor stops, it is necessary to wait 3 minutes before it restarts.
2
14 3568
7
Wireless operation
on indicator light
Timer indicator
light
Fan speed
indicator light
Bucket full
indicator light
Dryer operation
on indicator light
Unit operation
indicator light
Smart dehumidifying
operation on
indicator light
Continuous
operation on
indicator light